Limit Rockwell ACF Connection Speed
The following string must be used to limit the connection speed:
(NOTE: The 1MB ROM version of the ACF only holds 1 56k protocol. Either flex or v90, so use 11 for modulating under 56k)
+MS=<carrier>,<automode>,<min
rate>,<max rate>,<x law>,<reserved>,<max tx rate>
<carrier> =
Modulation. The selections are:
Value of
<carrier> |
Modulation Type |
Speed Range(bps) |
0 |
v.21 |
300 |
1 |
v.22 |
1200 |
2 |
v.22bis |
1200-2400 |
3 |
v.23 |
1200 |
9 |
v.32 |
4800-9600 |
10 |
v.32bis |
3800-14400 |
11 |
v.34 |
2400-33600 |
12 |
v.90 |
28000-56000 |
56 |
k56flex |
32000-56000 |
64 |
Bell 103 |
300 |
69 |
Bell 212 |
1200 |
<automode> = Automode.
The selections are:
Value of <automode> |
Option this selects |
0 |
Automode disabled |
1 |
Automode enabled using V.8 bis/V.8
or V.32 Annex A |
<min rate> = Lowest rate
allowed.
<max rate> = Highest rate allowed.
The selections are:
Allowed values for v.90(bps) |
Allowed values for k56flex(bps) |
Allowed values for v.34(bps) |
28000 |
32000 |
2400 |
29333 |
34000 |
4800 |
30667 |
36000 |
7200 |
32000 |
38000 |
9600 |
33333 |
40000 |
12000 |
34667 |
42000 |
14400 |
36000 |
44000 |
16800 |
37333 |
46000 |
19200 |
38667 |
48000 |
21600 |
40000 |
50000 |
24000 |
41333 |
52000 |
26400 |
42667 |
54000 |
28800 |
44000 |
56000 |
31200 |
45333 |
|
33600 |
46667 |
|
|
48000 |
|
|
49333 |
|
|
50667 |
|
|
52000 |
|
|
53333 |
|
|
54667 |
|
|
56000 |
|
|
<x law> = Specify Codec
type. (I would leave this blank (so you would have 2 commas next to
eachother), but if you want to change this:
Value of <x law> |
Codec Type |
0 |
m-Law (default) |
1 |
A-Law |
<reserved> =
Reserved. DO NOT CHANGE THIS (though specifying 0 is fine)
<max tx rate> = Max TRANSMIT
Rate. No need to change it, but here are the values:
300 |
1200 |
2400 |
4800 |
7200 |
9600 |
12000 |
14400 |
16800 |
19200 |
21600 |
24000 |
26400 |
28800 |
31200 |
33600 |
Example string:
+MS=12,1,32000,48000,0,0,33600
This page was last modified on Saturday, 05-Feb-2011 15:14:02 EST.
|