Rockwell based 14.4
Rockwell based 14.4
AT&FW2&C1&D2&K3&Q5S7=60S36=7S46=138S48=7S95=47
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
W2: Enables the CONNECT result codes to report the DCE speed.
&C1: DCD enabled after a carrier signal is detected
&D2: DTR drop causes modem to hang up
&K3: Enable RTS/CTS flow control
&Q5: Error correction mode
S7=60: Wait at least 60 seconds for carrier before discontinuing connection attempt.
S36=7: Attempt MNP, if MNP fails, the modem will fall back to an asynchronous connection.
S46=138: Modem will negotiate with a remote modem for data compression
S48=7: LAPM Error Control and Feature Negotiation enabled
S95=47: Enables the CONNECT result codes to report the DCE speed.
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
