Rockwell based 14.4 RPI+ Modem String Explaination
Rockwell based 14.4 RPI+ Modem
AT&F&C1&D3&K3+H11W2
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
&C1: DCD enabled after a carrier signal is detected
&D3: DTR drop causes the modem to be reinitialized
&K3: Enable RTS/CTS flow control
+H11: Enable RPI+ mode
W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
