Rockwell based 28.8 V.34/V.FC Modem String Explaination
Rockwell based 28.8 V.34/V.FC Modem
AT&FW2&C1&D2&K3&Q5%C3\N3S7=50S46=138S48=7
AT: (beginning of most inits) Attention!
&F: Sets the values loaded in the active profile to the values that are set in the default profile.
W2: (Extended result codes) sets modem to report CONNECT to DCE rather than DTE.
&C1: DCD enabled after a carrier signal is detected
&D2: DTR drop causes modem to hang up
&K3: Enable RTS/CTS flow control
&Q5: Error correction mode
%C3: This command sets the data compression to both MNP5 and v.42bis
\N3: Auto-reliable or MNP auto-reliable mode
S7=50: Wait at least 50 seconds for carrier before discontinuing connection attempt.
S46=138: Modem will negotiate with a remote modem for data compression
S48=7: LAPM Error Control and Feature Negotiation enabled
This page was last modified on Saturday, 05-Feb-2011 15:13:13 EST.
|
